Electrical hazards can exist in the office, too

May 3, 2021

 • BY Rob Ford

Most office environments are considered low-risk in terms of electrical hazards. But that doesn’t mean you should take safety for granted. Just because you’re not working on a factory floor with high-voltage equipment or are operating large machinery outdoors near power lines, don’t assume electrical hazards can’t be present.

A business setting should be up to code. But we all know mistakes happen, or shortcuts, unfortunately, get taken. No matter where you work, take account of your surroundings. Report things that make you go ‘hmmm.’ Don’t assume maintenance or management must already know about an issue you see and that everything must be OK.

Hazards and peculiar things office workers should keep watch for include:

  • Electrical cables that are frayed, loose or have exposed wires.
  • Outlets that are worn and won’t hold plugs snugly.
  • Electrical equipment that gives off a strange odor.
  • Overheating equipment (those not heated by normal operation). Beware of discolored plastic casings on the equipment or discolored outlet covers.
  • Overloaded outlets or extension cords.
  • Equipment that is not working properly

Any faulty equipment, wiring, plugs, etc., should be removed from use immediately and reported to your supervisor or whoever is in charge. Outlets should not be overloaded, so either plug equipment elsewhere or tell your supervisor, who should minimize the need for overloading them.

The office may need to have a licensed electrician install additional outlets and circuits to reduce overloading or the need to rely heavily on extension cords.

To minimize hazards:

  • Switch off and unplug appliances when they are not in use and before cleaning.
  • Turn off all appliances at the end of the day.
  • Do not force a plug into an outlet if it does not fit.
  • Do not run electrical cords through high-traffic areas, under carpets or across doorways.
  • Make sure the electrical load is not too much for any circuit, even when using a surge protector.
Rob Ford

Rob Ford

This email address is being protected from spambots. You need JavaScript enabled to view it.

Rob Ford is Tipmont and Wintek's communication director, a role he's held since 2015.

Rob has a bachelor's and a master's in Communication from Purdue University. He lives in West Lafayette with his wife and three children and has a life-sized Yoda statue in his office. Away from the office, you’ll find Rob working on his golf swing, jump shot, or hope for a Purdue basketball national title – all futile endeavors.

© Tipmont WIntek • Privacy Policy • All rights reserved.